Rice Lake Combination System - Precision Loads On-Board Weighing Systems - Manual (Page 9)

Load Cell Assemblies and General Specifications 5
3.2 Low Profile Bending Beam Load Cell
Model PL9000-14 load cell is designed for low profile use in a variety of on-board scale applications including
four and six point underbody mounts and body rest mounts for dump body and hoist chassis applications. Rated
dynamic capacity is 10,000 lbs (4500 kg) per load cell. The load cell is supplied with a single piece bearing plate.
Four 3/4"-16UNF x 2.00"L Grade 8 hex head cap screws bolt the load cell to its bearing plate. Angle brackets bolt
to the load cell with four 3/4"-16UNF Grade 8 bolts, to a bolt depth of 0.875" (22 mm). All eight 3/4" bolts used on
the load cell must be torqued to 400 lb/ft. This model load cell is also spring mounted in underbody applications.
A 13.00” (330mm)
B 2.84” (72mm)
C 3.00” (76mm)
D 4.60” (117mm)
E 11.50” (292mm)
F 2.33” (59mm)
G 1.00” (25mm)
H 6.50” (165mm)
J .75 x 16 UNF x .75 (19mm) deep, 4 places
K .75 - 16 UNF x 1.75 SAE grade 8 bolts
L 1.50” (38mm)
Figure 3-2. Model PL9000-14 Specifications
3.3 Underbody Shear Beam Load Cell
Model PL9000-14.4 load cell is designed for underbody and body rest mounts in four and six point system kit
configurations. Rated dynamic capacity of the load cell is 12,500 lb (5700 kg). End bolts of the load cell are 1-1/
8"-12UNF x 3.25" L Grade 8 and two bolts and washers are required for cell tie down. The load cell is supplied
with a single-piece bearing plate. Brackets mount to the load cell with two 1" diameter bolts. Bolt torque for the
1"bolt is 800 lb/ft (1085 Nm). This model load cell is also spring mounted in underbody applications.
Figure 3-3. Model PL9000-14.4 Cell Specifications