Rice Lake Digital Baby Scale (RL-DBS) - Operating Instructions - Manual (Page 8)

4 RL-DBS Operating Instructions
The RL-DBS Digital Baby Scale is pre-calibrated from the factory.
Use the following steps to set up your RL-DBS Digital Baby Scale when you initially power it up.
1. To operate the unit using the AC adaptor, plug the AC adaptor cable into the back of the scale as shown
in Figure 2-1, and the AC adaptor plug into a power source.
2. Press the
ON/TARE
key to turn on the scale.
3. When the self test function is complete, the digital display should read:
0:00.00
if set up in Lb/Oz or
0.00
if set up to read in KG.
4. Place a weight (not exceeding 40 lbs) on the scale. The weight calculation is complete once the motion
indicator turns on.
5. Press the
LB/KG
key to select the weight mode, either in pounds/ounces or kilograms.
6. Remove the weight from the scale. If you want to view the weight that was just on the scale, press the
RECALL
key.
If the setup procedure failed, refer to the troubleshooting section of this manual. If the problem is not
resolved, refer to a qualified service provider.
4.0 Scale Operation with Tare
The RL-DBS Digital Baby Scale can accurately weigh babies up to 44 Lb (20 Kg). Use the following steps to
weigh a baby.
1. Press the
ON/TARE
key to turn the scale on.
2. Wait until the
0:0.0
(if set up in Lb/Oz) appears on the digital display or
0.00
if set up in KG.
3. Place a pad on the weighing tray. Make sure that the edges of the pad are on the tray and are not touching
the surface on which the scale is positioned. The weight calculation is complete once the motion
indicator turns on ( o ).
4. Press the
ON/TARE
key to tare the weight of the pad or other accessory that is on the weighing tray.
5. Place the infant on the scale. The weight calculation is complete once the motion indicator turns on ( o ).
If the scale is being used with batteries and is not used for two minutes, it switches off to save battery life
and power. To restart the scale, press the ON/TARE key.
Note
Note
Note