Rice Lake Dual Ramp Wheelchair Platform Scale with Seat (350-10-4) - Rice Lake - Manual (Page 16)

12 Wheelchair Scale with Seat Technical Manual
5.1 Programming Mode Menu
Various parameters can be set while in programming mode.
Those parameters are shown in Figure 5-3.
Power Off
Power On-Off
START Kg-Lb Key
0.000
Software Version
Round xx
Full xxx
At
Press and
hold
OP1=X
SAVE
T-OFFX
DONE
OP2=X
OP4=X
OP3=X
OP5=X
OP7=X
OP6=X
OP8=X
Press and
hold the
Kg-Lb key
to advance
to option
2 through
option 8.
= DEF =
A TOLXX
Drange
A LEN X
MESS
A TImE XX
BAUD XX
Software ID
SET=X
OP9=X
OP10=X
GRAV x.xxxx
Figure 5-3. Programming Mode Menu Structure
Table 5-1 lists the various display messages and sequence when setting up the scale.
Parameter Description Choices Steps
FULL Full capacity of the scale Value (1000 lb) The display toggles between a numeric value and FULL.
If you don’t want to change the value, press the BMI key to
move to the next setting. Example: from FULL to LOAD. If you
want to change the value, use the following steps.
1. Press the ENTER key to change value starting with
the right most digit.
2. Use the Up/Down arrow keys to increment/
decrement numbers.
3. Press the BMI key to move to the left.
4. Use the Up/Down arrow keys to increment/
decrement numbers.
5. Press the BMI key again to move to the left
6. Use the Up/Down arrow keys to increment/
decrement numbers.
7. When done press the ENTER key to move to the
next parameter (LOAD).
Table 5-1. Configuration Mode Menu