Rice Lake IQ plus 355 Indicator Analog Option - Manual (Page 5)

December 2004 45774
IQ plus ® 350 Digital Weight Indicator
Analog Output Option
PN 43381
IQ plus 350 Analog Output Module Installation
To install or replace the analog output module, ensure
power to the indicator is disconnected, then place the
indicator face-down on an antistatic work mat.
Remove the screws that hold the backplate to the
enclosure body. Loosen all in-use cord grips then lift
the backplate away from the enclosure and set it aside.
Use a wrist strap to ground yourself and
protect components from electrostatic
discharge (ESD) when working inside
the indicator enclosure.
NOTE: Ensure jumpers JP1 and JP2 are installed in
position 1 (POS1) as shown in Figure 7.
Mount the analog output module on its standoffs in
the location shown in Figure 7 and plug the module
input into connector J5 on the IQ plus 350 board.
Connect output cable to the analog output module as
shown in Table 3, then reassemble the enclosure as
described on page 6.
Table 3. Analog Output Module Pin Assignments
Figure 7. Analog Output Module Installation and Wiring on IQ plus 350 Board
Caution Pin Signal
1 + Current Out
2 – Current Out
3 + Voltage Out
4 – Voltage Out
SW1
J7
JP4
J1
J4
F1
LOAD CELL CONNECTOR
SERIAL COMM & DIGITAL IN
KEYPAD CONNECTOR
F2
JP7
Setup Switch
Serial Communications Cable
to J4 Connector
Load Cell Cable
to J1 Connector
Line Filter Load Wires
to JP7 Connector
Setup Switch Wires
to JP4 Connector
Cable tie mounts on inside of enclosure top
Cable ties
JP1
JP2
Analog Output
Cable
7 6 5 4 3 2 1
1
2
3
4
5
6
7
J5
ANALOG OUTPUT
ANALOG OUTPUT MODULE
J1
4
3
2
1
JP1
JP2
POS1 POS2
POS2
POS1