Rice Lake MSI9300 PortaWeigh Crane Scale Calibration Guide User Manual
Page 5
Page 4 of 7
8)
Next, the MSI-9000 CellScale prompts for the value of the first calibration test weight.
This step defaults to capacity. If this is the actual calibration test load push Y, otherwise
push N to input the actual cal weight. If Y is selected, skip to step 10.
9)
If the calibration test weight is any value less than capacity. Type N to bring up the
to
change
screen. Type in the correct calibration TEST WEIGHT VALUE and press ENTER
to store the value.
10)
Load the scale with the indicated test weight. When the scale is stable press Y.
NOTE: When load is applied to scale, there will be a significant increase in the
Raw A/D Counts
. Actual
amount will vary depending upon rated mV/V output of load cell and percentage of capacity applied to
scale.
***** Channel Calibration *****
Calibrating Ch # 1-1, named:
….................
Precision in Kilograms :
10000. x 2.
Test weight # 0 in Kilograms :
0.
Test weight # 1 in Kilograms :
10000.
Press
(Y)
if this is correct
Press
(N)
to change
Press
(B)
to backup
Press
(ESC)
to exit calibration
***** Channel Calibration *****
Calibrating Ch # 1-1, named:
.................
Precision in Kilograms :
10000. x 2.
Test weight # 0 in Kilograms :
0.
Test weight # 1 in Kilograms :
10000.
Load the scale with test weight # 1
Press
(Y)
when scale is loaded and steady
Press
(B)
to backup
Press
(ESC)
to exit calibration
Raw A/D counts: 1649850
Type in the new test weight value:
7540
Kilograms