Rice Lake Okidata 320-390-420 Turbo - Service Guide - Manual (Page 83)

Page: 41
Service Guide ML320/321Turbo
Chapter 3 Parts Replacement
3.3.17 Change Lever and Gears
(1) Remove the upper cover (see 3.3.4 ).
(2) Release the reset spring 1 from the tab, remove it, then remove the idle gear 2, the tractor gear 4 and
the change gear 5.
(3) Push back the protrusion of the change gear shaft 6 gently with a flat blade screw driver to remove the
change lever 3. Note: The change lever can be difficult to remove; be careful not to exert too much force
with the screwdriver. Make sure the springs do not fly off when you release the change lever from the
shaft.
(4) To install, reverse the removal procedure.
Note on installation:
To insert the change lever into the change gear shaft 6, match the flat surface (D cut).
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)