Rice Lake Secura - Quintix and Practum Series - Application Guide - Manual (Page 5)

Enter the reference sample quantity by
touching the
application toolbar (factory
setting: 10 pcs); place this quantity in the
container and press w.
Add the first component to the
container and touch v to save the
component weight. The display will
change to 0.
3
3
3
The reference sample quantity you
entered will now appear on the display.
Place your total sample quantity in
the container.
Add the next component and save its
weight by touching v.
4
4
4
On the balance display, the piece count
of your sample will now be shown.
Touch
Qnt to view the total weight.
The total weight of your sample will
now appear on the display.
If necessary, you can add further
components. Touch
Net1 to view the
total weight.
5 6
5
5 6
Now the total weight is displayed with
a triangle (= calculated value).
You can continue to add further
components, if necessary.
6
Remove the container with your first
sample from the balance, the weight
reading will change to a negative value. Now place another empty container on
the balance and press D to tare (zero).
Afterwards, you can add component 2 and
confirm using v. To weigh-in further samples, repeat this
procedure. To display the total weight of
the components added so far, touch
Net.
The total of all saved components
will now be displayed (“Sum”) with a
triangle (= calculated value). Now you
can remove the container with the
last sample.