Rice Lake RS-130 - Calibration Instructions - Manual (Page 2)

Setting JP1 to the Enable/Disable Position
Follow the steps below to set jumper JP1 to the enable or disable position.
1. Remove platter and plastic in-use cover.
2. Remove lead-seal located in the center of the base.
3. Remove the 4 screws from the base of the scale.
4. Lift the cover away from the base toward the operator side.
JP1 Settings
Disable Enable
JP1
Note
Open slowly, cables are attached.
Figure 1. Jumper JP1 Location
Follow the steps below to re-assemble the scale.
1. Place the cover on top of the base, ensure that the sealing pin is aligned with the sealing pin hole in the
base.
2. tighten the 4 screws into the base of the scale.
3. Replace the lead seal in the center of the base, over the sealing pin.
4. Replace the platter and plastic in-use cover.
Sealing Pin
Figure 2. Sealing Pin