Rice Lake TradeRoute HL Series - Installation Checklist - Manual (Page 3)

Note
TradeRoute Checklist for Installation 3
1. When considering module positioning, refer to RLWS Installation Manual (PN 132555). See Section 2.2,
Scale Positioning, to establish the locations of scale modules based on body Center of Gravity (Figures 2-1
and 2-2)
2. When deciding on best module positioning, ensure that the moving part of the scale structure will have a
minimum of 2” (5 cm) free clearance in all directions.
3. When considering all issues, determine if a single module or a single/tandem module might be best suited
for the rear mount position, instead of a double module. If a single or single tandem is considered, make
sure there is clearance between chassis rails (width and depth). Measure for clearance with rear
differential, cross members, torque arms, etc.
Figure 4. Single Tandem Rear Mount located between Tandem Drive Axles
(Ref. Chalmers Suspension shown)
4. If the body is to be moved closer to or further from the cab, ensure that such re-positioning complies with
all legal vehicle length and axle weight and balance regulations and requirements.
5. The lowered scale adds 2.375 inches of height (6 cm) to the vehicle. Ensure that this height increase
complies with all legal vehicle height regulations and requirements.
6. Are there any rigid piping attachments between body and chassis-mounted components?
7. Consider service access to components when deciding on scale mounting locations.
8. Decide which specific method is to be used to attach the body to the scale modules.
Steel bracket to aluminum subframe Tipping body rear hinge and subframe
Figure 5. Attachment of Truck to body of Scale