Configuring the counterpart – Rice Lake WeighVault for Counterpart User Manual
Page 3
SCALES
FEATUR
PFORMT
VERS
XXXXXXX
ID
ACCUM
DISPLAY
TEST
SETUP
AUDIT
CALIBR
CONFIG
DIGI/O
SERIAL
ETHERNET
DHCP
NET MASK
DFLTGTWY
PORT
LC LMSTNM
DNSPRI
REMOTE IP
REMOTE PT
MAC
IP ADDRESS
VAULT
DNSSEC
3
Configuring the Counterpart
1. From the SETUP menu, navigate to CONFIG » ETHERNET.
2. Configure the ETHERNET menu’s parameters as shown in Table 1.
Figure 4.
Counterpart’s ETHERNET menu
Table 1. ETHERNET menu parameters and selections
Parameter
Description
Selection
DHCP
Dynamic Host Control Protocol
OFF (consult with network administrator)
IP ADDRESS
Assigns an IP address to the
Counterpart
Set to an available static IP address
(consult with network administrator)
NET MASK
Sets a subnet mask, if necessary
255.255.255.0 (consult with network administrator)
DFLTGTWY
Sets the default gateway, if necessary
Consult with network administrator
DNSPRI
Primary DNS, if necessary
Consult with network administrator
DNSSEC
Secondary DNS, if necessary
Consult with network administrator
LC LMSTNM
LCL name
Consult with network administrator
PORT
Port number
Port 10001
REMOTE IP
Remote IP address
IP address of the server/computer running WeighVault
REMOTE PT
Remote port
5466
MAC
MAC address
Addres of Ethernet (not changeable)
VAULT
Enable WeighVault
Set to ONBOARD to use the
Counterpart
’s onboard
Ethernet connection. Set to EXTERNAL to use the WLAN
option card (if installed)