Ring Communications DAD104m - Manual (Page 7)

NOVEMBER 2005 DAD104 DIGITAL ANNUNCIATOR DISPLAY
RING COMMUNICATIONS, INC. 7
REMOTE CONTROL - The Unmarked key
This key is used for Door Lock Control of the connected Substation.
DXC901 sends DTMF tone 5 to Substation.
DXC910 sends DTMF tone 5 to Substation.
DXA100 sends out event REMCON.
CANCEL A CONNECTION - The CANCEL key
When the intercom call is completed, press the C
ANCEL
key on the DAD104, this will cancel both the
intercom channel and the event on the current D ISPLAY L INE .
A F
AULT
will return within two seconds after being canceled if it is a solid F
AULT
(see P
ARK
). Faults can
occur intermittently during the scanning of the system due to electrical interference or disturbance at,
or near, the station or its cable. Each substation is scanned for faults 80 times per second.
HANDLING MULTIPLE INCOMING ANNUNCIATION -
When the Q UEUE indicator displays a number more than four (04), you can use the S CROLL U P / D OWN
keys to view the additional events and decide which lines should be handled first. If the scrolling
feature is not used, calls can be handled on a first in first out basis by starting at the uppermost active
line. When each call is canceled each D
ISPLAY
L
INE
will automatically move up, and the top active
D
ISPLAY
L
INE
can be used each time until all lines are handled.
SILENCING THE AUDIBLE ANNUNCIATOR TONE -
When an incoming annunciation is received and cannot be handled immediately, the tone can be
temporarily silenced by pressing the C
ANCEL key. If any additional activity occurs, the audible tone will
sound again.
The audible tone will also sound if another event is received while you are presently handling one.
Two options are available to handle a event while in conversation: One is to complete the present call,
press cancel, then proceed to handle the additional events. The second option is to place the present
call in P
ARK , then answer the additional events to assess the priority of the call handling using P ARK or
C
ANCEL
as needed.
NIGHT TRANSFER MODE -
The DAD104 is placed in Night Transfer mode by placing the associated intercom station in privacy.
Calls to this DAD104 will now be sent to the next DAD104 in the Annunciator chain (for the sub
station) without the programmed delay. The delay is used in normal Day mode to delay calls before
they transfer (Max delay 9.9 minutes). When the DAD104 is in transfer mode the time display will
flash the word “TRANSFER” . Calls are still qued in the DAD104 but the beeper is silenced. The
beeper will beep once every 40 seconds as a reminder that the we are in transfer mode. The DAD104
may answer calls in the Que while in transfer mode.