Ring Communications DNA934P - Manual (Page 15)

February 2013 Telephone Dialer with Recorder DNA934P
CB901CA CONFIGURATION
(CB901+DXC901)
The DNA934P consist of one station port and one annunciator port in the Central exchange.
The interface can be used to manually dial out on the telephone line from a master station by
dialing the extension of the DNA934P. A telephone can dial in to the central exchange by
dialing the phone number of the DNA934P then dial any intercom extension.
When the DNA934P receives a transfered call it will dial the telephone numbers that are
programmed in choices 1-4.
Example:
Adding the DNA934P to an existing system.
Connect voice to call number 130 subscriber address 1E.
Connect date to RS485 using Network address 0C.
Calls are to transfer from intercom 100 to the DNA934P if not answered by intercom 100
within 30 seconds.
Programming commands that need to be added to CB901CA:
For subscriber address 1E set device type = 2 (ICM)
For subscriber address 1E set annunciator = 0C
For each substation (type 1) set annunciator address 2 = 0C, delay = 5 (5x6=30 seconds)
Page 15
Ring-Master