Sage Kinetix Control BBL605UK - Manual (Page 11)

10
oPeratIng yoUr neW aPPLIanCe
note
Do not fill the blender jug above the
MAX line. When the blender jug is filled
at or near the MAX line place one hand
on the blender lid to avoid displacement
of the lid during operation.
6. Select the required speed (1 to 5) by
pressing the corresponding speed
button. The blender will start to
operate and the selected speed button
will illuminate. The POWER button
will illuminate and cease to flash.
The STOP button will illuminate
and flash. The LCD timer screen
will start counting upwards in one
second increments until 120 seconds
is reached.
note
Operate the blender only for the
appropriate amount of time required –
do not over blend.
7. When 120 seconds is reached,
the blender will automatically
cease to operate and the selected
speed button and STOP button
illumination will go out. The
POWER button will illuminate and
flash. After a few seconds the LCD
timer screen will revert to ‘00’.
note
• The Blender will automatically
stop blending after 120 seconds (2
minutes). This is a safety feature and
restricts wear on the motor.
• To stop blending at any time, press
the STOP button or the selected
speed button. The POWER button
can also be pressed, but this will
also turn the appliance off and all
illuminations will go out.
• The speed can be changed at any
time during the blending process.
Each time a new speed is selected
its button will illuminate and the
previous speed button illumination
will go out. The number of seconds
on the LCD timer screen will
continue to count upwards to 120
seconds unless interrupted.
8. The blender features two additional
pre programmed functions, ICE
CRUSH and SMOOTHIE and a
PULSE function. These two pre-
programmed cycles automatically
adjust the blending time and speeds
to optimise blending results. Select
the required function by pressing
the corresponding function button.
The blender will start to operate and
the selected function button will
illuminate. The POWER button will
illuminate and cease to flash. The
STOP button will illuminate and
flash. The LCD timer screen will start
counting backwards in one second
increments until ‘00’ is displayed.