Sage Smart Kettle BKE820UK - Manual (Page 13)

12
PAge heAder..... oPEratIng yoUr nEW aPPlIanCE
BEforE fIrSt USE
Remove and safely discard any packaging
material or promotional labels attached to
your kettle. It is recommended that before
first use to fill the kettle to the maximum
level with cold tap water, bring to the boil by
selecting the BOIL 100° button, then discard
the water. Your kettle will only operate when
positioned on the power base. The kettle will
automatically switch off when the water has
reached the selected temperature.
oPEratIon of yoUr KEttlE
1. To fill the kettle, remove it from the
power base and open lid by pressing
the lid release button. Fill with the
desired amount of water.
notE
Always fill the kettle between the
minimum (500ml) and maximum
(1700ml) marks on the water window.
Too little water will result in the
kettle switching Off due to the safety
boil dry protection. Filling above the
maximum mark (MAX) may result in
boiling water splashing from
the kettle.
2. Ensure the lid is closed and locked
firmly into place. Position the kettle
securely onto the power base. Insert
the power plug into a 230V power
outlet and switch on. The START/
CANCEL and 100° BOIL button
surrounds will illuminate in white for
one minute. A beep will sound for
two seconds. The START/CANCEL
button surround will automatically
switch off after one minute if
not selected.
notE
If the START/CANCEL button
is pressed (before selecting a
temperature button), the
START /CANCEL button surround
will illuminate in red and the 100º
button surround will illuminate and
the kettle will start heating.
3. Select the desired setting by
pressing one of the five temperature
buttons (80°, 85°, 90°, 95°, 100°).
The selected button and the START/
CANCEL button surround will
illuminate in white.
notE
The KEEP WARM function can
be selected before, during or on
completion of the water heating cycle
(refer page 9).
4. Press the START/CANCEL button
and the surround will illuminate
in red, the selected temperature
button surround will illuminate and
the kettle will start heating. Do not
remove the kettle from the power
base during operation. Ensure the
kettle has switched off after the
water has boiled or the selected
temperature has been reached before
removing the kettle from the power
base. If the kettle is removed from
the power base during the KEEP
WARM function the kettle will
automatically switch off.
5. When the kettle has heated the water
to the selected temperature, 3 beeps
will sound, the START/CANCEL
button surround illumination
will switch off, and the selected
temperature button surround will
remain illuminated for
1 minute before switching off.