Cisco 10005 - Manual (Page 12)

Adding or Replacing an AC Power Supply
12
Cisco 10005 ESR AC Power Supply Installation
78-12652-01
Step 8 Snug up the strain relief device that secures the power cord to the power supply.
To do this, tighten the screw underneath the connector (
Figure 6 ).
Figure 6 Tightening AC Power Cord Strain Relief
Warning Do not over-tighten the strain relief devices that secure the power cords to
the power supplies. Because this chassis cannot be switched off
completely, you must disconnect the power cords to remove power from the
chassis. The power cord serves as the primary disconnect in an emergency.
Step 9 Plug the power cord into a power receptacle.
When you connect power to the power supply while it is in standby mode, the
yellow Fault LED lights up.
Step 10 Set the power switch on the new power supply to the | (On) position.
The green Power LED on the power supply lights up, indicating that the power
supply is supplying power to the chassis. The yellow Fault LED goes out.
53630
CAUTION
THIS UNIT HAS MORE
THAN ONE PO
WER
SUPPL Y CORD
. DISCONNECT
TWO (2)
POWER SUPPL
Y CORDS BEFORE
SERVICING
TO AV OID ELECTRIC SHOCK.
CAUTION
100-240V
50/60 HZ
15-7A
FAULT
CAUTION
THIS UN IT HAS M
ORE THAN
ONE PO WER
SUPPL Y CORD . DISC ONNECT TW
O (2)
POWER SUPPL
Y CORD S BEFOR
E
SERVIC ING TO AVOID ELEC TRIC SH
OCK.
CAUTIO N
100-240V
50/60 HZ
15-7A
POWER
FAULT