Cisco 10005 - Manual (Page 14)

Related Documentation
14
Cisco 10005 ESR AC Power Supply Installation
78-12652-01
You can determine whether your equipment is causing interference by turning it
off. If the interference stops, it was probably caused by the Cisco equipment or
one of its peripheral devices. If the equipment causes interference to radio or
television reception, try to correct the interference by using one or more of the
following measures:
• Turn the television or radio antenna until the interference stops.
• Move the equipment to one side or the other of the television or radio.
• Move the equipment farther away from the television or radio.
• Plug the equipment into an outlet that is on a different circuit from the
television or radio. (That is, make certain the equipment and the television or
radio are on circuits controlled by different circuit breakers or fuses.)
Modifications to this product not authorized by Cisco Systems, Inc. could void the
FCC approval and negate your authority to operate the product.
Related Documentation
This section lists the manuals in the Cisco 10000 series documentation set.
Manuals for All Cisco 10000 Series Routers
• Technology of Edge Aggregation: Cisco 10000 Series Edge Services Router
• Cisco 10000 Series ESR Performance Routing Engine Installation
• Cisco 10000 Series ESR OC-12 Packet Over SONET Line Card Installation
• Cisco 10000 Series ESR OC-12 ATM Line Card Installation
• Cisco 10000 Series ESR Single-Port Gigabit Ethernet Line Card Installation
• Cisco 10000 Series ESR Channelized OC-12 Line Card Installation
• Cisco 10000 Series ESR 6-Port Channelized T3 Line Card Installation
• Cisco 10000 Series ESR Channelized STM-1 Line Card Installation
• Release notes for the Cisco 10000 series ESR
These documents, which are available at Cisco.com, are online only:
• Cisco 10000 Series ESR Software Configuration Guide
• Cisco 10000 Series ESR Troubleshooting Guide