SINGER CE-150 Futura - Manual (Page 62)

3. PREPARATION FOR EMBROIDERY SEWING
BEFORE ATTACHING EMBROIDERY UNIT
ATTACHING EMBROIDERY FOOT
Always be sure to turn off power to machine
before changing presser foot.
∗ Raise presser foot lifter.
∗ Turn hand wheel toward you until needle is in its highest
position.
1. Remove presser foot screw, presser foot and foot holder.
2. Attach the embroidery presser foot behind presser bar so
that the drive lever is above the needle clamp. Secure it by
tightening presser foot screw.
3. Turn hand wheel toward you to move needle up and down,
and check that the embroidery presser foot moves up and
down together with the needle.
Be careful not to touch the needle when
replacing presser foot.
INSERTING THE BOBBIN
Refer to page 16 - 17.
∗ A large amount of thread is required for embroidering,
so be sure to use full bobbin.
Foot holder
Support du pied
Sujetador prensatelas
Presser bar
Barre de pied presseur
Barra de prensatelas
Screw
V i s
Guia
Embroidery presser foot
Pied presseur de broderie
Prensatelas de bordado
Presser foot
Pied de biche zigzag
Pie prensatelas
Drive lever
Levier d’entraînement
Palanca de accionamiento
Needle clamp
Serre-aiguille
Abrazadera de aguja
CAUTION
CAUTION