Smart Power Systems Office-TBF UPS - Manual (Page 10)

Battery Replacement
Follow the charts below to replace the batteries.
After removing the battery cover, gently extract batteries from the case.
Disconnect the two wires connecting it to the Office Series UPS and
replace it with the same type of batteries. Dispose of the old batteries
properly at an appropriate recycling facility.
11
12
14
13
Chart 1
Chart 2
Chart 3
9
Bottom View
Bottom View
Bottom View
Remove the screws located on the bottom of the UPS to open the
battery cover.
DC Start Function
DC Start Function enables UPS to be started up when AC utility power is
not available and battery is fully charged. Just simply press the power
switch to turn on the UPS.
Green Power Function
All Office Series UPS are equipped with Green Power Function. If no load
connects to the UPS, it will automatically shut down in 5 minutes for
energy saving during power failure. The UPS will restart while AC
recovery.
10