Snow Joe SPX1000 Pressure Joe 1450 PSI 1.45 GPM 11.5-Amp Electric Pressure Washer - Manual (Page 8)

8
4. Slide the hose/cord holder into position (Fig. 4).
5. Fit the two pieces of the spray wand assembly together
and rotate it until the two parts are completely locked
(Fig. 5).
6. Fit the spray wand assembly into the gun and turn the
rotatable end-piece of the wand until the two parts are
completely locked (Fig. 6).
7. Connect the quick-connect end of the high-pressure hose
to the trigger gun (Fig. 7). You will hear a click when it
snaps into place. To release the high-pressure hose from
the trigger gun, push the release button on the trigger gun.
8. Connect the other end of the high-pressure hose to
the water outlet on the pressure washer (Fig. 8). First,
push the high-pressure hose end completely onto the
high-pressure water outlet, then screw it on clockwise.
m
WARNING! Keep hose away from sharp objects.
Bursting hoses may cause injury. Examine hoses regularly and
replace if damaged. Do not attempt to mend a damaged hose.
9. Connect the garden hose adaptor (female coupler) to
the water inlet of the pressure washer, then thread your
garden hose (male end) into the garden hose adaptor
(Fig. 9). The garden hose must have an internal diameter
of at least 13 mm (1/2 in.) and must be reinforced. The
water supply must be at least equal to the washer delivery
capacity.
NOTE: The machine is not suitable for connection to the
potable water main.
Fig. 4
Hose/cord holder
Fig. 5
!
RELEASE
Spray wand assembly
Trigger gun
Fig. 6
Push to release
Trigger gun
Fig. 7
RELEASE
High-pressure hose
Fig. 8 (FRONT)
High-pressure
water outlet
High-pressure hose