Snow Joe SPX1000-RM Pressure Joe 1450 PSI 1.45 GPM 11.5-Amp Electric Pressure Washer - Manual (Page 6)

The water supply must be at least equal to the washer
delivery capacity.
NOTE: The machine is not suitable for connection to the
potable water main.
7. Attach garden hose to water supply (Fig. 6).
m
WARNING! The intake water temperature must
not exceed 104 ºF/40ºC. The water supply must not
exceed 0.7 MPa.
m
CAUTION! The washer must only be used with clean
water; use of unfiltered water containing corrosive chemicals
will damage the washer.
8. Push the motor switch to the OFF (0) position (Fig. 7).
9. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specified on the washer
rating plate. If the power supply is correct, you may now
plug the washer into the power outlet (Fig. 8).
Operation
m
IMPORTANT!
This pressure washer is equipped with
a micro-switch sensitive to water flow. This Total Stop System
(TSS) senses water flow in the pump. When the trigger is
released, water stops flowing through the pump. The TSS then
automatically turns the motor off to protect the pump from
overheating.
1. Turn the water supply tap on completely.
2. Unlock the safety lock (Fig. 9), then press the trigger for
a few seconds until water flow is steady to allow air to
escape and to discharge residual pressure in the hose.
3. Keeping the trigger pressed, turn the switch to the ON (1)
position to start the pressure washer.
4. When re-starting the motor, always keep the trigger
pressed.
NOTE: The motor only runs when the trigger is depressed
and shuts off when the trigger is released.
Fig. 5
(REAR)
Water inlet
(female coupler)
Garden hose
This end to
water inlet Garden hose
(male end)
Fig. 6
Connect to water supply
Garden hose
OFF
ON
1
0
OFF
ON
Fig. 7
Fig. 8
GFCI
!
RELEASE
Fig. 9
Trigger
Safety lock
Push to release
high pressure hose
6