Snow Joe SPX3000-RM Pressure Joe 2030 PSI 1.76 GPM 14.5-Amp Electric Pressure Washer - Manual (Page 8)

13. Attach garden hose to water supply (Fig. 17).
m
WARNING!
The intake water temperature must not
exceed 104 ºF/40ºC. The water supply must not exceed
0.7 MPa.
m
CAUTION! The washer must only be used with clean
water; use of unfiltered water containing corrosive chemicals
will damage the washer.
14. Push the motor switch to the OFF (0) position (Fig. 18).
15. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specified on the washer
rating plate. If the power supply is correct, you may now
plug the washer into the power outlet (Fig. 19).
Operation
m
IMPORTANT! This pressure washer is equipped with
a micro-switch sensitive to water flow. This Total Stop System
(TSS) senses water flow in the pump. When the trigger is
released, water stops flowing through the pump. The TSS then
automatically turns the motor off to protect the pump from
overheating.
1. Turn the water supply tap on completely.
2. Push the safety lock down and into its original position
(Fig. 20), then press the trigger for a few seconds
until water flow is steady to allow air to escape and to
discharge residual pressure in the hose.
Fig. 16
Water inlet
(female coupler)
(FRONT)
Garden hose
This end to
water inlet Garden hose
(male end)
Fig. 17
Connect to water supply
Garden hose
OFF
ON
1
0
OFF
ON
Fig. 18
Fig. 19
(GFCI)
Fig. 20
Safety lock
Slot
8