Cygnett i-x6 - Manual (Page 9)

Installation
Dock your iPod here
Remote Control receiver
Insert appropriate
iPod adaptor for
your iPod here
iPod connector
1. USB 2. DC In 3. Audio Connection 4. S-Video
6
Connecting to your iPod
Connecting the dock and i-X6 Speakers
1. Connect the dock to the speakers using the included 5 metre Audio
(3) and DC (2) cable to connect the audio and provide power
to charge your iPod.
2. For viewing video footage, connect the S-video cable to the dock (4)
and into your television. This requires an iPod with video
capabilities. Make sure video output is set to on & settings on your
iPod are correct. ie. PAL or NTSC.
3. To sync your iPod with your computer, connect the included USB
cable from the dock (1) to your computer. Your iTunes should
automatically start after a short while and sync with your iPod.
4. Once you have connected the cables to the rear of the dock, slot in
the appropriate insert for your iPod. Then dock your iPod on the
iPod connector
To take full advantage of the stereo sound, we recommend you
place the dock close to the centre of your entertainment system and
separate the speakers.
5. To adjust the volume via the dock press the (+) or (-) buttons on the
front of the dock or on the remote.