Snow Joe 322P-RM Plus 12-Inch 7.5-Amp Electric Snow Thrower - Manual (Page 3)

Upper and Lower Tube Assembly
1. To secure parts during shipping, a wire is wrapped
around the upper and lower tube sections. Remove it, but
don’t discard (Figure 1).
2. Slide the lower tube (B) into the upper tube (A) (Figure 2).
Note : Before you connect the tubes, you may find it easier to
remove the slack in the wire. Slightly pull the wire from the
bottom of the lower tube (B) before you join the tubes together.
Assembly
CAUTION
m m
Inspect wiring, which, if damaged during shipping,
may cause serious bodily injury during equipment
use. If any damage is seen or suspected, do not
assemble. Instead, contact Snow Joe customer service
(1-866-SNOWJOE) for assistance.
Handle with care during assembly so that electrical
wiring does not become damaged.
Figure 1
A
A. Shipping wire
3
A
Adjustable handle
B
A. Upper tube
B. Lower tube
Figure 2
322P_MANUAL_ENG_RM_Document 1 2/16/11 1:26 PM Page 3