Snow Joe 322P-RM Plus 12-Inch 7.5-Amp Electric Snow Thrower - Manual (Page 7)

2. Using an open end wrench, loosen the nut between the
body and the rotor (counterclockwise). Hold the loosened
nut and turn the outer body bolt counterclockwise. Remove
nut, bolt, and washers (Figure 9). Storage
CAUTION: Store electrical appliances in a locked area away
from children and unauthorized users.
1. Before storing, inspect the entire appliance for any damaged
or worn parts. Check connections and screws and tighten
if necessary. Check blade condition. Examine the extension
cord and its plug for excess wear or damage, and replace
if warranted.
2. Store the snow thrower safely out of harm’s way and prevent
access by unauthorized users, preferably by placing in a
locked cabinet. Keep away from dust and humidity by
loosely covering with a tarp and using de-humidifying
products as conditions warrant.
3. Keep the extension cord with the appliance. If the entire
appliance is locked away, keep the key in a container or
plastic bag, tied or taped to the handle so it isn’t lost. If the
appliance isn’t locked up, it is advisable to store the key in a
separate secure place to prevent unauthorized use.
Service and Support
If your Snow Joe 322P electric snow thrower requires service
or maintenance, please call 1-866-SNOWJOE for assistance.
Model and Serial Numbers
When contacting the company, reordering parts, or arranging
model and serial numbers, which are found on the decal on the
lower tube. Copy these numbers into the space provided
below.
7
3. Pull out the rotor starting at the left side (Figure 10).
Figure 9
C. Bolt
D. Flat washer
E. Flat washer
F. Nut
Figure 10
G. Rotor
Note: You may need to pull out the rotor using both hands.
Please wear gloves to prevent injury.
4. Install the new rotor reversing the above steps.
E
F
C
D
G
Model #:
Serial #:
Please record the following numbers from the housing or handle of your
new product:
3 2 2 P R M
322P_MANUAL_ENG_RM_Document 1 2/16/11 1:26 PM Page 7