Snow Joe SJ620-RM Ultra 18-Inch 13.5-Amp Electric Snow Thrower - Manual (Page 5)

Assembly
Getting Started
1. Remove the snow thrower and all other items from the
box.
2. Determine the left and right hand side of the snow thrower
by standing in the normal operating position.
3. Check all items for shipping damage. If damages are seen
or suspected or if any of the parts are missing, do not
assemble. Instead, promptly inform the dealer where you
bought the snow thrower or contact Snow Joe Customer
Service for assistance.
4. Check to make sure upper chute crank is included.
Upper, Middle, and Lower Frame
Assembly
1. The machine is packed ready to go. Pull the middle frame
back (Fig. 2). For easy assembly, we packaged the model
with most parts connected. Pull the upper frame up
(Fig. 2).
2. Secure the connection of lower frame and middle frame
by fastening the knobs on each side (Fig. 3).
3. Secure the connection of middle frame and upper frame
by fastening the knobs on each side (Fig. 4).
Discharge Chute Assembly
1. Loosen the knob to lift the chute deflector (Fig. 5).
m
CAUTION
m
Inspect wiring, which, if damaged during shipping, may
cause serious bodily injury during equipment use. If any
damage is seen or suspected, do not assemble. Instead,
contact Snow Joe Customer Service (1-866-766-9563)
for assistance.
Handle with care during assembly so that electrical
wiring does not become damaged.
Figure 2
Figure 3
Figure 4
Figure 5
5