Universal Remote Control (URS) MX-650 User Manual
Page 17
32
31
U n i v e r s a l R e m o t e C o n t r o l , I n c .
From the RF Settings Menu, select IR/RF.
Decide whether you are changing the Signal for all devices or just
one of the devices of the Omega.
Select ALL to change the signal settings to
ALL devices in the Omega. Then, go to Step
4.
Select DEVIC to change the signal settings to
just one of the devices in the Omega. Then,
go to Step 3.
The display changes to a list of the names of your devices. If you have
two pages of devices, pressing either of the page buttons will display
the other page. Select the device you would like to change IR/RF set-
tings, then go to Step 4.
Select the new setting by pressing the desired button, then press SAVE
to save your new setting and return to the RF settings menu.
T h e O m e g a
1
2
4
3
Change IR from ON to OFF.
Change RF from ON to OFF.
Save the new setting
Select a device
Page Button
displays the
other page
of devices.
Exit this Menu without changing
the IR/RF settings
Press the RF button.
The RF Settings Menu appears. See the notes on the following
pages for more info on each option. Make your selection by press-
ing the button you want:
After you’ve made a new setting and SAVED your change, use the
EXIT button to return to the Setup menu. Use the MAIN button to
return to normal operation.
IR/RF Signal Setting
You can set the signal to be IR line-of-sight only, RF only or IR and RF
simultaneously. Additionally, you can set the signal the same way for ALL
ten of your devices OR you can set the signal differently for each device
(the plasma TV could be set to be IR line-of-sight only, while the DVD
player and the Satellite receiver are set to be RF only). A good reason to set
the signal to RF only is to prevent too much IR being sent to a sensitive
component from two arrivals at the front panel (one directly from the
Omega, one from the RF base station). A good reason to set the signal to
IR only is that another room has an MRF-100 base station (no RF address)
so it will receive commands from the Omega unless it is set to IR only.
3
4
5
RF Button
Signal (IR,
RF or Both)
Base Station
ID #
Emitters - ALL
or a specific
Emitter
Blaster - Turn
the Blaster
On or Off
Exit this Menu