Universal Remote Control (URS) MX-650 - Manual (Page 6)

10
T h e O m e g a
The display will show a list of the first ten devices. If you would like
to teach a command to a device on Page 2, press the PAGE button.
Select the device you would like to teach commands to by pressing
the Device button.
You’ve selected the Device you want, no select any button you want
to teach a command to (if it is on another page, press the page button).
Note: The only buttons you can’t
teach IR commands are the
PAGE, MAIN and FAV buttons.
Once you press a button, the top of the display will change from
“LEARN” to “READY”.
4
5
6
Press any Button.
Press the
Page button
to display
the other ten
Device
names.
First ten
Device Names
Repeat steps one through nine for each of your devices. Test all the
commands you’ve programmed. If you are missing any commands,
use the learning method, described next: 10
9
U n i v e r s a l R e m o t e C o n t r o l , I n c .
Learning Method
The Omega can learn commands from your old remote controls one-
button-at-a-time on any button of any device, on the MAIN or FAV LCD
buttons or on the MAIN hard buttons, by following these simple steps:
Line-up the Omega with your old remote control, head-to-head,
one or two inches apart.
On the Omega, press and hold the MAIN and ENT (Enter) buttons
at the same time for approximately three seconds. The top of the
display will show “SETUP”. You are in SETUP mode now.
Note: You have 30 seconds to perform a step while you are in SETUP mode. If
you don’t press a button within that time, the Omega will time out and return to
normal operation.
Press the LEARN button.
The top of the screen will change to “LEARN”.
LEARN
Button
1
2
3