Universal Remote Control (URS) MX-600 - Manual (Page 22)

21
5. Programming the MX-600 to Control Your Components
6. Press the button on the MX-600 you wish to program.
Only the three MAIN, PAGE and FAV buttons cannot be
programmed.
7. Press the button on your original remote control that you
wish to program onto the MX-600. Once the MX-600 has
received the signal, the MX-600 will flash “Good” on the
LCD screen, indicating it learned the code correctly.
(Please do Step #6 within 20 seconds of Step #5, otherwise
the remote will revert to the SETUP menu, and then after a
period of time, it will go back to the MAIN device page.)
If it flashes “Fail”, repeat from Step 4 until it learns
successfully.
8. Return to Step #3 until you have programmed all of the
buttons that you require.
9. Once you complete the programming and wish to exit
the LEARNING mode, press the MAIN button. Exit from
the SET UP mode by pressing the MAIN button once
again.
Tip: Learning to VOL, CH and Transport buttons: If you
are having problems learning to the Volume, Channel and
Transport buttons, it may be that you have previously
assigned a “Punch Through” from another device to that
device. To remove a Punch Through, just punch through
the device to itself. For example, to erase a punch through
from a TV to an Audio Device, just punch through the TV
to the TV.
(See “Programming Punch Through” functions on
Page 32.)