Universal Remote Control (URS) MX-600 - Manual (Page 37)

36
7. Press the MAIN button to exit to main Erase mode.
8. Press the MAIN button once again to exit the SETUP
mode.
C. Erasing Macro Functions
1. Erase M1, M2, M3, POWER ON and POWER OFF
Buttons
1. Go to the SETUP mode by pressing both the MAIN and
ENTER buttons simultaneously for three seconds.
2. Press the ERASE button next to the LCD screen.
3. Press the MACRO button.
4. If you wish to erase all of the macro buttons in the
MX-600, press the ALL button and then press the SURE?
button at the next LCD screen.
5. If you wish to erase just one of the macros, press the
KEY button at step 4 and then one of the M1, M2, M3,
POWER ON or POWER OFF buttons to erase the macro
functions from that button.
6. Repeat from Step #5 to erase any other macro buttons
you require.
7. Press the MAIN button to exit to main Erase mode. Press
the MAIN button once again to exit the SETUP mode.
9. Erasing Existing Programming