Campbell Hausfeld CC640 - Manual (Page 55)

Appendix B. Quick Set-up and Test Procedure
STEP 9: Press the ‘Setup’ button again and observe that the video output turns
off. Pressing the setup button toggles the video output on and off. Ensure that the
video output is off for the next step.
STEP 10: Press the ‘Snap’ button. The LED will flash twice and the video output
will momentarily turn on and then off. You have just initiated an image
acquisition by using the manual Snap button.
Refer to the CC640 manual for operation with a compact flash NOTE
memory card. If a properly formatted memory card is inserted in
your camera, pressing the Snap button will store the images to the
memory card.
STEP 11: You may now toggle the power switch to the Auto position. You can
disconnect your power supply at this point or you may refer to the manual and
follow the procedures to configure the camera for your necessary application.
B-3