Wine-Mate SSWWC Series - Manual (Page 18)

- 17 -
Fig. 4 WM-150~250SCU Condensing Unit
Fig. 5 Liquid Filter Fig.6 Liquid Indicator
2. Temperature Controller and Air Probe Installation
1) The air probe shall be located in the wine cellar 5 ft above the floor or the air
return area, but it shall not be located in the air supply area or other areas
where air is not circulated.
2) Air probe can be pulled out of the temperature controller around 5 ft; if
additional wires are needed, 18 gauge wires may be used to extend the air
probe.
3. Evaporator Unit Installation
1) The WM15~25SFCW evaporator units shall be installed for wall mount with
the air supply on the top and air return on the bottom.