Workrite Poise - Manual (Page 2)

2 Workrite Ergonomics 800.959.9675 www.workriteergo.com
Workrite Poise™
FLAT SCREEN MONITOR ARM
Contents
Important Safety Instructions ............................ 2
Components and Fasteners ................................ 3
PA1000 Assembly Instructions ............................ 4
LCD Monitor Attachment .................................... 5
Cable Management ........................................... 6
Arm Adjustment ............................................... 7
Desk Base Template .......................................... 8
Important Safety Instructions
Read and understand all these safety
instructions before using the product.
Do not mount the Desk Base of the Arm on an
unstable surface or any surface that could not
mount the Desk Base firmly.
For safety reasons, the internal gas-strut of
the LCD Arm product was pre-adjusted in the
factory to the lowest force to prevent the Arm
body from being recoiled during installation.
During installation, beware of the recoil of
the Arm body when attaching or detaching
the LCD monitor to the Arm. To prevent dam-
age or injury when changing the LCD monitor,
always readjust the gas-strut to the lowest
force level to control the recoil of the Arm
body when the LCD monitor is detached.
Do not attempt to disassemble, service or
modify the product by yourself.
Use only a slightly damp cloth to clean the
Arm surface. Never apply flammable solvents
like alcohol, benzene, thinner, etc. to the
product.