Workrite SwingArm–Dual - Manual (Page 2)

2 Workrite Ergonomics, Inc
SwingArm–Dual™ Installation Instructions
Important Safety Instructions
Read and understand all these safety
instructions before using this product.
Do not mount the clamp base or the grommet base on an unstable surface
(any surface that will not hold the base firmly).
For safety reasons, the internal gas-strut of the SwingArm–Dual™ is pre-
adjusted at the factory to the lowest force for the prevention of arm body
recoil during installation.
IMPORTANT SAFETY PRECAUTION:
During installation, beware that the arm body can move suddenly when
attaching or detaching the LCD monitor to the Swing. WHEN CHANGING
THE LCD MONITOR, ALWAYS RE-ADJUST THE GAS STRUT TO THE LOWEST
FORCE SETTING. Without this adjustment, the arm will move suddenly up-
ward when the monitor is removed.
Do not attempt to disassemble, service or modify the product yourself.
Use only a slightly damp cloth to clean the Arm surface. Never use flam-
mable solvents like alcohol, benzene, thinner, etc.
Table of Contents
List of Boxes ................................................................................................. 3
List of Parts .................................................................................................. 3
Step 1: Attach Clamp Base to Work Surface ...................................................... 6
Step 1x: Attach Grommet Base to Work Surface ................................................ 6
Step 2: Attach Monitor Arms to Monitors .......................................................... 7
Step 3: Attach Pivot Base and Arms ................................................................. 8
Step 4: Vertical Movement Adjustment ............................................................. 9
Step 5: Ball-joint Adjustment for Tilt Action ...................................................... 9
Step 6: Final Touches: Cable Management ...................................................... 10