Zippy RHI-6460P User Manual
Page 9
9
REMOTE SENSE
for OUTPUT
VOLTAGE
+5V,+3.3V
NON -
DISTINCTION
OCP
To compensate the voltage outputs drop caused by the copper loss in
longer cable run, two sets of VOLATGE REMOTE SENSE
(+5V,+3.3V) are provided in RHX series.
The OCP designs are identical in either one of power module or both
of two modules of the RHX series power supply system.
+12 V BUILT-IN
SMART
REGULATOR
A high efficiency, linear smart regulator is built in for each +12V
output.
SOFT SWITCH
A 2.54 pitch and 3 pin connector is provided to match the control
switch which endures extremely small current (Including two
different mode of operation: One Remote On / Off Disable mode and
another always On mode). Please refer to Section 1.8 "Soft Switch
On / Off installation" for more details.
HOT - PLUG - in
FUNCTION
A Hot-Plug-in function is provided in this system, It allows the
power supply units in either Disk Array or File Servers to be
removed or inserted with ease without opening and closing from
chassis.
SAFETY
( CHECK
VENDOR )
Since the power supply unit in Disk Array / File Server are all of
DC , ( Including power for I / O Switch , and some other drives ), it
prevents a person from being shocked down by high AC voltage
during any installation or Hot-Swap procedure.
AC INPUT FULL
RANGE
No worry about failure of power supply unit because of your
different power sources. Full range of input voltage for each RHX
POWER MODULE is available covering from 90V to 264V single
phase AC voltage..
ACTIVE POWER
FACTOR
CORRECTOR
Active POWER FACTOR CORRECTOR in RHX design is useful
to reduce more than 63% of input RMS current better than any
conventional power supply unit, and to upgrade the power source
utilization, which is recognized by the EN61000-3-2 regulation.
ELECTRO-MAG
NETIC
INTERFERENCE
Our Built - in EMI suppression circuit to eliminate any electro -
magnetic interference are fully complying with CISPR 22
(EN 55022) ,
FCC code.
COMPATIBILITY
(RHD only)
The enclosure of RHD power supply system is designed identical to
the Big L form factor power supply, so that the Big L form factor
and the redundant power system can be compatible under the
proper arrangement.