Coway BA07-R - Manual (Page 11)

11
For Inf
orma
tion
PAR
TS NAME / KEEP IN MIND
KEEP IN MIND
 Connect the power.
Turn on by connecting the power plug to the electrical outlet and pressing the
power selection button on the control panel. The bidet works normally only
when the electricity is connected.
 Open the main water supply valve.
The main water must be supplied to operate the bidet normally.
 Check whether the product is in power saving mode
before use.
- When there isn’t a seat sensor sensing and a button operation, if you set
the power saving mode.
· After passing about 1 minute : The warm water/seat temperature
setting becomes as a ‘Low’ status.
· After passing about 30 minutes : The product is switched to the power
saving status when the indicator in the control panel is putted out.
- In the power saving mode, the power indicator is turned off. Press any
button to switch the product to the waiting mode and then use the bidet.
- If the power indicator is not turned on when a button is pressed on the
control panel, as the power is turned off, please turn on the power before use.
This product is for 120 V~ 60 Hz only.
Please connect the power plug to a dedicated grounded
electrical outlet for 120 V~ 60 Hz .
Tips
1014692 BA07 »з¿л¼³¸н¼- ¹МБЦЗв_(08.09.10).indd 11 2008-09-10 ¿ААь 11:36:38