Chariot Carriers Captain XL - Manual (Page 8)

8
4.3 Wheel assembly
Wheel assembly on the Cabriolet
TIP
The easiest way to assemble the wheel is to lay the carrier
on its side.
To assemble the wheel, push the axle into the axle socket until
it can go no further. As you do this, the spring clip of the
axle socket must audibly engage in the axle groove of the
wheel.
Spring clip
Test for proper assembly by trying to pull the wheel outwards
after assembling. The wheel’s axle should remain locked in the
axle socket and cannot be pulled outwards.
To remove the wheel, pull the spring clip out of the hole in the
axle socket and pull the wheel out of the axle socket.
Wheel assembly on the Captain XL and Corsaire XL
The wheels of the Captain XL and Corsaire XL are equipped
with so-called push-button axles. Pressing on the rubber cap in
the wheel centre will loosen the retaining balls which lock the
axle in the axle socket. The wheels can only be assembled and
removed with the plastic cap pushed in.
DANGER
Always check that both wheels are properly seated by pulling
the wheel hard to one side. To do this, lift the carrier, and
make sure that the fi tted wheel cannot be pulled off, by giving
it a few good shakes on each side.
DANGER
Always check that both wheels are properly seated by pulling
the wheel hard to one side without pressing the unlocking
button. To do this, lift the carrier, and make sure that the fi tted
wheel cannot be pulled off, by giving it a few good shakes on
each side.
TIP
The easiest way to fi t the wheel is to lay the carrier on its
side.
To fi t the wheel, press in the rubber cap and insert the wheel
axle into the axle socket until it can go no further. Release the
rubber cap. By moving the wheel from side to side, check that it
is locked in the axle socket and cannot be pulled off.