Garmin GPS 120 - Manual (Page 59)

To flush m ount the G PS 120:
The GPS 120 can be mounted flush with a flat
panel of .08- 52” thickness using the cam lobe feature
on its mounting bracket,
I. C ut a 4.15" W X 4.67" H hole in panel.
1
Place G PS 120 into hole from the front until its flange rests against
the m ounting surface.
3. From the back side of the panel, loosely attach
the bracket such that the slot in the ratchet area
points aw ay from the m ounting panel.
4. Rotate the bracket (tow nw ard until the panel
is pinched tightly betw een the the units flange
and bracket lobe.
5. Tighten knobs and connect the pow er/data
and antenna cables.
To sw ivel m ount the G PS 120 (w ith optional sw ivel m ount bracket):
1. Place the sw ivel m ount bracketin the desired
location.
2. M ark and dnil the three m ounting holes for the
fasteners you are using.
3. Fasten the bracket to the surface using the
appropriate fasteners.
4. Place the m ounting bracket on top of the sw ivel
m ount bracket, and secure using the knob included
w ith the sw ivel m ount kit Insert the G PS 120 into
the m ounting bracket.
5. Screw the tw o m ounting knobsthroughthe bracket and into the G P S 120.
C onnect the pow er/data and antenna cables to the back of the unit
51