Cambridge Audio PS2000 - Manual (Page 6)

6
Speaker Connections
Using the Dual RCA to RCA plug,
connect the R (right) and L (left) Speaker
inputs located on the back panel of the
Dipole Unit to the corresponding
Speaker outputs on the Subwoofer.
Using the Dipole DIN cable, connect
the DIN jack of the Dipole Unit to the
DIN jack of the Subwoofer.
For information on connections to
signal sources, refer to “System
Connection Diagram” on page 7.
Power Supply Adapter
Connections
Confirm the power switch on the
Subwoofer is in the “OFF” position.
Insert the Power Adapter’s AC plug into
an appropriate receptacle. Insert the
small DC connector into the 15V DC IN
jack on the back of the Subwoofer.
Dolby Digital source
Connect the Dolby Digital/SPDIF output
of your signal source to the Subwoofer’s
Dolby Digital (AC-3) SPDIF IN jack
using the SPDIF Cable (RCA to RCA)
or the Optical Cable.
Game consoles
Connect the optical output of the game
console (e.g. PlayStation 2) to the
Optical input with the Optical Cable.
If the optical connection is not
available or is being utilized, use the
Stereo to Dual RCA Cable and the
Dual Female RCA Adapter to connect
to the game console’s RCA output of the
multiple A/V plug.
For devices with optical output
Connect the optical output of these
devices (e.g. CD or MD players) to the
Optical input with the Optical Cable.
Note: Optical connections have priority
over coaxial (SPDIF RCA to RCA)
connections.
For all other sound cards
Use the Tandem Audio Cable. Connect
the lime-green stereo miniplugs from the
Line Out minijack output of your sound
card to the Line In minijack input of the
Subwoofer. Connect the black stereo
miniplugs from the Rear Out minijack
output of your sound card (if present) to
the Rear In minijack input of the
Subwoofer.
Speaker System Connections Signal Source Connections
PS2000 Digital_UK.book Page 6 Thursday, August 3, 2000 10:53 AM