Chicago Electric 7" Electronic Polisher 66615 - Manual (Page 10)

Page 10 For technical questions, please call 1-800-444-3353. SKU 66615
SPECIFICaTIONS
Electrical Specifications 120 V~ / 60 Hz / 10 A
No load speed 1000~3500 RPM
Maximum Accessory Size 7” Diameter
Mounting Disc Type 7” Hook & Loop
Variable Speed Switch Sliding Button (+ & -)
Display Unit of Measure RPM x 100
Accessories Polishing Bonnet
Foam Bonnet
Sanding Disc - 80 Grit
uNPaCKINg
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon as
possible.
INSTRuCTIONS FOR PuTTINg
INTO uSE
Read the ENTIRE IMPORTaNT
SaFETY INFORMaTION
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
TO PREVENT
SERIOuS INjuRY
FROM aCCIdENTaL
OPERaTION:
Turn the Power Switch (11) off
and unplug the Polisher from its
electrical outlet before
assembling or making any
adjustments to the tool.
Note: For additional information regarding the
parts listed in the following pages, refer
to the Assembly Diagram near the end of
this manual.
aSSEMBLY
FIguRE B
SPINdLE
LOCK (34)
MOuNTINg
dISC (51)
auXILIaRY HaNdLE (36)
gEaR BOX
(32)
1. To attach the Mounting Disc (51) to the
Polisher, press and hold the Spindle
Lock (34). Screw the Mounting Disc
onto the Spindle (50) of the tool. Then
release pressure on the Spindle Lock.
To attach the Auxiliary Handle (36),
2.
screw the Handle firmly into the threaded
mounting hole located on either side of
the Gear Box (32).