Using external devices, Installing the cisco unified ip phone – Cisco 7965G User Manual
Page 5
3-5
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 7.0
OL-15427-01
Chapter 3 Setting Up the Cisco Unified IP Phone
Installing the Cisco Unified IP Phone
Using External Devices
The following information applies when you use external devices with the Cisco Unified IP Phone:
Cisco recommends the use of good quality external devices that are shielded (screened) against
unwanted radio frequency (RF) and audio frequency (AF) signals.
Depending on the quality of these devices and their proximity to other devices such as mobile phones or
two-way radios, some audio noise may still occur. In these cases, Cisco recommends that you take one
or more of the following actions:
•
Move the external device away from the source of the RF or AF signals.
•
Route the external device cables away from the source of the RF or AF signals.
•
Use shielded cables for the external device, or use cables with a better shield and connector.
•
Shorten the length of the external device cable.
•
Apply ferrites or other such devices on the cables for the external device.
Cisco cannot guarantee the performance of the system because Cisco has no control over the quality of
external devices, cables, and connectors. The system will perform adequately when suitable devices are
attached using good quality cables and connectors.
Caution
In European Union countries, use only external headsets that are fully compliant with the EMC Directive
[89/336/EC].
Installing the Cisco Unified IP Phone
You must connect the Cisco Unified IP Phone to the network and to a power source before using it. See
for a graphical representation of the connections.
Note
Before you install a phone, even if it is new, upgrade the phone to the current firmware image.
Before using external devices, read the
“Using External Devices” section on page 3-5
for safety and
performance information.
To install a Cisco Unified IP Phone, perform the following steps:
Table 3-1
Installing the Cisco Unified IP Phone 7965G and 7945G
Task
Purpose
Related Topics
1.
Connect the handset to the Handset port.
—
2.
Connect a headset to the Headset port.
Optional. You can add a headset later if you do not
connect one now.
See the
for supported
headsets.
3.
Connect a wireless headset.
Optional. You can add a wireless headset later if you
do not want to connect one now.
Refer to the wireless headset documentation for
information.