Crimestopper Security Products CS2016 Dpfm - Manual (Page 5)

5
WIRING: 9-PIN Connector
M.A.P. can be used to interrupt power/accessory wiring to prevent unauthorized access of the vehicle’s audio or
entertainment systems when Valet Park mode is ON. See Mobile Accessories Protection Diagram below.
86 85
+
IGN.
87
SWITCHED
30 87A
START
IGN
ACC
CUT
OFF
FM 105. 5
wire of mobile accessories such as Audio system
Connect relay as shown to interrupt the power
RADIO
GREEN/RED
M.A.P. OUTPUT
MOBILE ACCESSORY PROTECTION
or Cellular telephone. The Alarm will disconnect
these accessories when in VALET PARK MODE.
Blue/Black: (-) IGNITION OUT or REMOTE AUX. Output #2 (Programmable, See Programmable Option #17)
This wire functions as a Negative IGNITION OUTPUT (Ground while Remote Starting) for use when connecting
factory Security Bypass modules or when an additional external Ignition Relay is required for your installation. This
wire can be programmed to function as an AUXILIARY OUTPUT #2 providing a momentary (-) Negative output
when Button #5 then #1 is pressed and held for more than 2 seconds. The Aux Channel #2 output stays on as long
a the button is held down. Connect to the Negative activation circuit of an auxiliary module or device.
Blue/White: (-) Passenger Door Unlock Output (Optional, requires relay)
This wire activates when the unlock button on the remote is pressed a second time upon disarming. This wire is
used for the Optional Separate Driver’s/Passenger Unlock feature. Connects to unlock circuit for passenger door or
doors. See DOOR LOCK WIRING for special configuration options.
Orange: (-) Negative Starter Disable/Anti-Grind Output
This wire should be connected to the Yellow wire of the pre-wired relay socket for the starter disable. Connect the
blue wire of the relay socket to the Ignition switched wire on the vehicle. Cut the vehicle starter wire and connect
each half to an Orange wire on the relay socket. This output also turns on with remote start to function as an “Anti
Grind” wire to prevent the starter from grinding if you get in your car and turn the key too far after it was remote
started. See starter disable diagram on next page.