Cabletron Systems 9A100 - Manual (Page 28)

2-10 SmartSwitch 9A100 User Guide
Using the Console Switch Installation and Setup
If you don’t specify parameters with the command, the console prompts you for an input value and provides a default
value displayed in parenthesis. For example, if you enter
show portconfig without specifying a port (as a parameter),
the following appears. Here, the default of “ all ” ports is presented. You can either accept the default by pressing Enter,
or you can enter a specific port number. Taking the default displays the following:
SmartSwitch # show portconfig
PortNumber(ALL) :
Port Intf Sig Trans Media Speed Oper
ID Type Type Type Type (MB/s) State
==============================================================================
A1 private pnni10 STS-3c MMF (S) 155 MB UP
A2 private autoConfig STS-3c MMF (S) 155 MB DOWN
A3 private autoConfig STS-3c MMF (S) 155 MB DOWN
A4 private autoConfig STS-3c MMF (S) 155 MB DOWN
B1 private autoConfig STS-3c MMF (S) 155 MB DOWN
B2 private autoConfig STS-3c MMF (S) 155 MB DOWN
B3 private autoConfig STS-3c MMF (S) 155 MB DOWN
B4(CPU) private uni31 STS-3c MMF (S) 155 MB UP
C1 private autoConfig STS-3c SMF (I) 155 MB DOWN
C2 private autoConfig STS-3c MMF (S) 155 MB DOWN
C3 private autoConfig STS-3c MMF (S) 155 MB DOWN
C4 private autoConfig STS-3c MMF (S) 155 MB DOWN
D1 private autoConfig STS-3c CAT5 UTP 155 MB DOWN
D2 private autoConfig STS-3c CAT5 UTP 155 MB DOWN
D3 private autoConfig STS-3c CAT5 UTP 155 MB DOWN
D4 private autoConfig STS-3c CAT5 UTP 155 MB DOWN
SmartSwitch #
2p›F When you accept the ( all ) default for show , the information displayed is often
abridged.
2.5.2 Console Time-out
The console can be configured to exit if it does not sense a key stroke within a defined length of time. By default, the
SmartSwitch 9A100 is set to never time-out (value = 0). To activate the time-out feature, use the
set ConsoleTimeOut
command to adjust the time-out period:
SmartSwitch # set consoletimeout
Timeout(0) : 30 <Will time-out in 30 minutes without input
Confirm (y/N)? : y
SmartSwitch #
2.5.3 Creating an Alias
Use the add alias command to create shorter or easier-to-remember names for command lines. For example:
SmartSwitch # add alias
AliasName() : traffic
AliasedString() : set switchtrafficcongestion
SmartSwitch #