Fitting to the stand, Assembly – Panasonic TYST65PF1 User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Assembly
3. Fitting to the stand
w
"5)
c
LU
Before fitting the dispiay, make sure to iock the casters.
Do not lift up the display higher than
necessary.
• Ifthe display is lifted too high, it may faii down
and personal injury may result.
Locking and unlocking the casters
Caster locked
Caster unlocked
1. Fitting the display
©Engage the upper insulation spacers ofthe
display with the cutouts at the top of the mobile
stand, and slowly lower the display into place.
©While lifting the display slightly, insert the bottom
insulation spacers into the holes at the lowerend
of the mobile stand, and then lower the display
straight down into place.
Push the bottom
of the lever
Push the top of
the lever
Upper insulation spacer
2. Fixing the display
Firmly tighten the screws (2) for securing unit
® in the screw holes on the upper part of the
mounting bracket (2).
(Tightening torque: 1.2 to 1.5 N-m)
Make sure to fit the screws for securing unit © on the
left and right to prevent the display from coming off.
28