Allen Sports SST1 - Manual (Page 9)

INSTRUCTIONAL
OWNER’S MANUAL
p
9
INSTALLING JOGGER WHEEL
FIGURE 32.
FIGURE 35
FIGURE 33.
FIGURE 34.
STEP 2:
STEP 3:
STEP 3:
WARNING!: Failure to properly install and adjust wheels with Quick Release levers could allow wheel to come off
during use. This could lead to serious injury or death.
STEP 1:
NOTE:
CAUTION:
NOTE:
After aligning the front wheel in the fork slots, slide the wheel all the way into the
front fork (Fig 33).
The front axle has a flat area on it that you must align with the slots in the front
fork (Fig 32).
IMPORTANT: PLEASE FOLLOW INSTRUCTIONS FOR QUICK RELEASE LEVER
The Jogging Stroller is equipped with a Quick Release front wheel. Place the
Stroller so the rear wheels and handle are touching the floor.
You cannot tighten the Quick Release lever by merely twisting the lever. You can
only ensure it is locked by properly tightening the finger nut and then flipping the
Quick Release lever from “Open” to “Closed”
If jogger fails to roll straight, loosen QR lever and reposition wheel in the fork
slots to correct the realign the wheel, and then retighten the QR.
With the wheel in position and the quick release lever in the “Open” position,
tighten the finger nut on the axle until it is very close to contacting the fork
(Fig 34).
Move the lever into the “Closed” position. You should feel significant resis-
tance when closing the lever. If you do not, open the lever and tighten the
finger nut a bit more and close the lever again. Continue to do this until the
movement of the lever results in tension on the lever when closing and the
wheel is tight in the frame (Fig 35).
When you complete the wheel installation process, attempt to pull wheel
from frame; if wheel moves, tighten the finger nut and repeat the test.