Allen&Heath ZED POWER - Manual (Page 25)

Allen & Heath 25 ZED POWER 1000
Main Mix Out XLR connectors
Standard XLR output connectors for the main stereo
mix. Impedance balanced to aid interference rejection.
A recessed switch on the rear panel reduces the level
by 30dB if it is required to submix these outputs into
the XLR inputs of another mixer.
Main Mix Insert jack sockets
Standard 1/4” (6.25mm) jack sockets wired:
Tip = send, Ring = return, Sleeve = Chassis. Nomi-
nal level is 0dBu.
Use for connection of outboard equipment such as a
master compressor or limiter.
Effects & Aux bus Outputs
Standard 1/4” (6.25mm) jack sockets wired:
Tip=hot, Ring=cold, Sleeve=Chassis. 0dBu.
The FX out is the Effects bus output, and can be
used for connecting to external equipment such as
an effects processor. OR a latching footswitch can
be connected (wired between Tip & Sleeve) and
used to mute the on-board FX.
The AUX out is taken from after the AUX MIX mas-
ter level control.
48v to Microphones
Switches industry standard 48v (phantom power)
to all microphone inputs for use with condenser
microphones.
Aux Mix Level control
The master volume control for the Aux mix bus. Ad-
justs the level from off (fully attenuated) to +6dB gain.
Main Mix Fader
This is the master level control for the main stereo
mix. The fader has 10dB of gain at the top.
MASTER SECTION
2 Track Level control and switch
The 2 track replace LR switch cuts the main LR feed
from the mixer to main mix out and replaces it with the
2 track signal via the level control. This is useful for
playing music or announcements during a break from
live sound.