Industrial Injection 5.9L Dodge Cummins Dual CP3 - Manual (Page 3)

Dual Fueler CP3 Pump Kit 03-07 5.9L Dodge Cummins Dual Fueler CP3 Pump Kit 03-07 5.9L Dodge Cummins
6 3
1. Remove Radiator Hose, Fan Shroud Bracket and Engine Belt.
2. Remove Idler Pully, and replace with #5a Idler Pully as shown (fig.
2a), by using the stock spacer (remove it from the stock pully, fig. 2b)and
inserting #5b Washer as shown (fig. 2c, 2d). Install this assembly back
onto engine (same place as fig. 2a).
3. Remove Harness wire bracket bolt, and
move to position as shown from arrow 1 to
arrow 2 (fig. 3a)
fig 2a.
fig. 2b
fig. 2c
fig. 2d
4. Remove inlet high pressure fuel line from stock fuel pump (fig. 4a) and
fuel rail (fig 4b).
fig. 4a
1
2
fig. 3a
13. Cut return fuel and supply line hoses 3/4” as shown below, and insert
#2 & #3 5/16” T fittings to Return Fuel Line and Supply Fuel Line hoses.
Secure with #11 hose clamps.Then connect #2 Supply line and #3 Return
Line to Dual Fueler Pump, secure with #11 hose clamps. Return Line
Supply Line
Supply Line
Return Line
14. Install Fuel Pump Pully,
torque nut to 35 ft lbs. 15. Install new engine belt. Follow
the belt routing below.
12. Install #15 High Pressure Line Fastener as shown. Install #4 High
Pressure Fuel Lines as shown below to stock engine pump, fuel rail,
and Dual Fueler pump all connected with #9 fuel T connector .
dual fueler high perssure line
fig. 4b
#9
fuel rail
stock pump
#15