Maglite MAGTAC™ LED Rechargeable Flashlight System Plain Bezel - Manual (Page 3)

Getting Started
Congratulations
You have just made an investment in
one of the most highly-advanced precision
instruments in illumination technology.
The MAG-TAC® LED Rechargeable Flashlight
System was formulated on precision and quality.
Derived from many years of experience in the
precise world of fine machine tools, our
flashlights quickly became recognized for form
and function and most importantly to you, the
consumer, for quality and dependability.
Taking a few moments to read this
manual and familiarizing yourself with the
MAG-TAC® LED Rechargeable Flashlight System
will help to insure years of superior service and
satisfaction.
Consult the accompanying chart and obtain the
model number from your package to see which
of the following 8 items your package contains:
Mag Instrument is a Founding Partner
of the National Law Enforcement Officers Memorial
Fund and The National Law Enforcement Museum.
Learn more about The Campaign for the
National Law Enforcement Museum at www.maglite.com
Section 1
Unpacking and Setup
1
1. Flashlight
2. Charging Base
3. USB Cable
4. 120V Adapter (US)
5. 12V Adapter (Automobile)
6. 240V Adapter (AUS)
7. 240V Adapter (UK)
8. 230V Adapter (Euro)
9. Clip
5 4
Contents
Getting Started . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Unpacking and Setup . . . . . . . . . . . . . . . . . . . . 5
Charging the Battery. . . . . . . . . . . . . . . . . . . . . . 6
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Troubleshooting, Specifications . . . . . . . . . . . . 8
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Français . . . . . . . . . . . . . . . . . . . . . . . . 10
Español . . . . . . . . . . . . . . . . . . . . . . . . 26
Rechargeable System
Systéme Rechargeable
Sistema Recargable
1. Remove light from package.
2. Unscrew tailcap.
3. Remove battery insulator (round disc) located at rear of battery.
Insulator should fall out of barrel when light is tilted head up.
4. Install pocket clip onto barrel from the tailcap end (push round part
of clip all the way forward until it stops on knurl). Insert cam lock
tool into cam lock and rotate clockwise approximately ¼ to ½ turn,
to lock pocket clip on barrel.
5. Screw tailcap back onto barrel.
6. Remove charging cradle, USB cable and wall adapter from package.
7. Connect cable to charging cradle, wall adapter or cigarette adapter.
Then plug into appropriate power source.
8. Install assembled light into charging cradle and charge until fully
charged (solid green LED indication on cradle).
Charging Base
There are provisions for mounting the cradle if desired. Any #10 or
M3.9 screw with a low profile truss head, will go through the center of
the charging cradle. Screw head must be no larger than an .484 in. or
12.3 mm.
And, head height must be no longer than .130 in.
or 3.3 mm. Use appropriate threads for the type of
material to which the cradle is mounted.
Mount vertically only on horizontal surface with
open end up.
2
3
6
7
4
5 9
8
4
7
3