Maglite MAGTAC™ LED Rechargeable Flashlight System Plain Bezel - Manual (Page 4)

Section 2 Section 3
Charging the Battery
6
Total time to fully charge a dead battery is approx. 2.5 hours.
Before using your MAG-TAC®, place it in the charging cradle for at least one
hour, or until the LED indicator shows solid GREEN.
Your MAG-TAC® charger is compatible with PC USB ports. NOTE however,
charge times are slightly longer with a PC USB port than with the provided
MAGLITE® adapters.
DO NOT use any charging cradle, wall adapter, or generic battery charger
other than the ones provided with your MAGLITE®.
Make sure your light is Turned OFF (Mode 5) before inserting it into the
charging cradle.
Fault : Charger output is below the minimum threshold for normal
operation. Short circuit on charge terminals or component failure is
detected.
Pre-Conditioning : Battery is dead. Cradle will charge battery at very low
rate, it will then proceed to Fast Charge.
Fast Charge : Cradle will fast charge the battery up to approximately 80%
capacity.
Top-Off : Battery is at 80% capacity, cradle will perform a slow charge until
battery is 100% capacity.
Maintenance/Idle : Charge is complete. The cradle will maintain a FULL
charge state. The flashlight is left in the cradle and as the battery voltage
drops slightly over time, the cradle will switch between Top-off and an idle
state.
Battery removal and replacement
(only necessary when battery has reached the end of service life)
1. Use battery nut wrench to unscrew battery nut. Install wrench into Barrel
(tailcap end) and twist until wrench locates into nut. Continue to turn wrench
counterclockwise until nut is fully unscrewed.
Note: if wrench is unavailable the new battery has a hex on the negative end
that can be used.
2. Remove battery from barrel.
3. Install new battery into the barrel with hex end first (negative end),
toward the head end of the light.
4. Install battery nut into barrel and use wrench to tighten nut. (can also use
old battery)
Note: use caution not to cross thread battery nut into barrel.
5. Screw tailcap back onto barrel.
MAG-TAC ® LED RECHARGEABLE- C HARGING C RADLE F UNCTIONS
LED Indicator Charger Mode Battery State
Blinking RED Fault FAULT
RED Pre-Conditioning DEAD
ORANGE Fast-Charge LOW
Blinking GREEN Top-Off PARTIAL CHARGE
GREEN Maintenance FULL CHARGE
GREEN Idle NO LIGHT
7
Operation
Switch Operation
User input ‘clicks’ must be performed within 0.5 Seconds of
each other.
If your MAG-TAC® appears to go dim immediately after
turning it ON, it means your battery is almost dead. Charge it.
Rated Light Output is per ANSI specifications, with a fully
charged battery.
Rated Run-Time is per ANSI specifications, with a fully
charged battery, and with the light turned on and left on
constant.
Notes:
DO NOT attempt to use any battery other than the one
provided with your MAGLITE®.
Make sure your light is Turned OFF (Mode 5) before inserting
it into the charging cradle.
When not in use, your MAG-TAC® Flashlight should be
turned OFF and left in the charging cradle.
MAG-TAC ® LED R
ECHARGEABLE
- F
UNCTIONS
User Input Mode Output Run-Time
1 CLICK (hold) 1-Momentary ON HIGH-520 Lumens 2.5 Hours
2 CLICKS 2-Latch ON HIGH-520 Lumens 2.5 Hours
3 CLICKS 3-Power Save Low-100 Lumens 4.5 Hours
4 CLICKS 4-Strobe STROBE-450 Lumens@12Hz >4.5 Hours
5 CLICKS 5-OFF / Charge OFF N/A