Magnum Dynalab MD-106T - Manual (Page 8)

- 8 -
CHECKING OUT YOUR MD 106T
1. Place your power switch to the “ON” position (B on diagram). This should turn
on your tuner’s meter lights and frequency display.
2. Place your STEREO/MONO switch (D on diagram) to the Stereo setting.
3. Place your bandwidth switch (E on diagram) to BW1.
4. Place your Mute switch (C on diagram) to “ON” position.
5. On your preamplifier/ integrated amplifier select the input that your MD 106T
tuner is connected to.
6. Rotate the tuning knob on your tuner (F on diagram) until sound is heard
through your speakers, now fine tune this station using the center tuner meter
(J on diagram) and signal strength meter (H on diagram) as indicators. Your
stereo light on the face of your tuner should be on. Place the stereo/mono
switch (D on diagram) to the Mono position, your stereo light should now go
off. Now turn the stereo/mono switch back to the Stereo position and your
stereo indicator light should turn back on.
7. You are ready now to search through FM frequencies in search of your
favorite stations. If you encounter difficult reception situations please read the
Controls and Functionality section of your manual.
8. Approximately 48 hours of “burn in” should eliminate any measure of drifting
that you may encounter with your new tuner. Please note that when your tuner
is turned off for more than a couple of hours, upon powering “ON” your tuner,
you may encounter a slight amount of drift on the station you were last tuned
to. Please do not touch the dial, as when the tuner warms back up, it will
return to where it was last center tuned.