Magnum Dynalab MD-309 - Manual (Page 8)

- 8 -
7. Hit the button marked “SSP” and then “Save”.
8. When the screen goes back to the main screen it should now read SSP and the
volume control will have no effect on the level.
HOOKING UP A SUBWOOFER TO YOUR SYSTEM
1. Unplug the power cord to the MD 309 Hybrid Integrated Amplifier.
2. Using RCA cables, connect one end to the
Pre Out output marked on the rear of
the 309, the other end to your subwoofer.
3. Turn the subwoofer “ON”.
4. Re-connect the power to the MD 309 Hybrid Integrated Amplifier. Push the
“POWER” button to the “ON” position and adjust the volume level to suit you.
Please note the volume of the subwoofer is controlled by the volume control on the
Hybrid Integrated Amplifier.
DIGITAL AUDIO CONVERTER (D.A.C) OPTION
If you chose the Digital Audio Converter (D.A.C.) option, an additional USB, and two
(2) coaxial inputs have been installed in the back of the MD 309 Hybrid Integrated
Amplifier.
1. Connect an external source to the USB, or either of the coaxial inputs.
2. Turn the input dial to the corresponding input selection on the front of the MD
309 Hybrid Integrated Amplifier.